Philips 37HFL5682L, 42HFL5682H, 42HFL5682D, 42HFL4482F Install TV Channels, Default setting is No

Install TV Channels

This TV is equipped with Helptext which will time out in 10 sec or upon Remote Control key press.

■Install TV Channels: This option allows you to Install TV channels. For the “Install TV Channels” option, you can do the setting for following options in sub-menu:

•Scan Type: “Cable” to receive TV signals from a cable, “Air” to receive TV signals from an antenna.

•Install TV Channels: “Auto”,“Manual”

•Confirmation page to “Start” the TV channels tuning.

•System Searching Status:“Digital Channels Found”, “Analog Channels Found”

Note

It is important to understand the difference between physical channel numbers and TV program numbers. When Auto Install is selected, the TV first scans for digital channels, starting at a physical (RF) channel 2 and then increasing in frequency to 3, 4, .... The first digital

program it finds will be installed on TV program 1, the second on TV program 2 etc. Then the TV scans for analog channels. For the sake of discussion, let’s assume that the TV found 36 digital programs. Then the first analog channel found would be installed as TV program 37, the second as TV program 38 etc. This could be a big change as most hybrid analog/digital systems have the analog programs on the lower physical channels and the digitals on the higher. But this is only the initial order that the Auto Install creates - the final order of the channel map that you wish to present to the guest is fully programmable.

■Install TV Settings: This option allows you to Install TV setting. For the “Install TV Settings” option, you can do the setting for following options in sub-menu:

•Select Your Power On Setting:“Last Status”,“On”, “Standby”, “Forced On”

•When power to the TV is interrupted, this function sets the state that the TV will return to when power is restored.

•If set to Standby, the TV will always resume into Standby mode when power is restored (default setting).

•If set to Last Status, the TV will resume to the mode it was in when power was lost.

•If set to On, the TV will always turn-on into On mode when power is restored.

•If set to Forced On, the TV will turn-on to On mode, but it cannot be turned off. (For applications where TV is always on and you do not want anyone accidentally turning it off.)

•Default setting is Standby.

•Select Your Keyboard Lock Setting: “ No”, “Yes”, “All”.

•This function enables/disables the Keyboard buttons on the TV.

•If set to No, all keys are enabled. If set to Yes, all keys are locked except for the Power key. If set to All, then all keys are locked including the Power key.

•Default setting is “No”.

9