Philips 32PF9531/10 instruction manual Troubleshooting

	Troubleshooting	EN
Symptom	Possible cause/Remedy
No picture	< Verify if the supplied cables are connected properly. (The aerial cable to the
	TV, the other aerial to your recorder, the power cables, ..)
	< Verify if you selected the correct source.
	< Verify if the child lock has been switched off.
Poor picture	< Verify in the Manual installation menu if you have selected the correct TV
	system.
	< Verify if your TV or house aerial isn't located too close to loudspeakers,
	non-earthed audio equipment or neon lights, etc.
	< Mountains or high buildings can cause double pictures or ghost images.
	Sometimes you can improve the picture quality by changing the direction of
	the aerial.
	< Is the picture or teletext unrecognisable or do you experience bad teletext
	reception ? Verify if you have entered the correct frequency, or fine tune the
	frequency for that specific channel or adjust the antenna direction if the
	problem isn’t solved by finetuning. See Installation, Manual installation, p. 23.
Poor colour	< Select Factory settings in the Installation menu.
	< Verify the connections between the optional equipment and the TV.
No sound	< Verify if the volume isn't at minimum.
	< Verify if the sound hasn't been muted with the ¬ key.
	Verify the connections between the optional equipment and the TV.
The remote does	< Verify if the remote is set correctly for the equipment your are using.
not function	< Verify if the batteries are not dead. Replace the batteries.
	You can still use the keys at the left side of the TV.
	< Select TV mode on your remote control.
	< When pressing a key and some key leds are blinking with a higher speed
	and lower intensity than in a normal working condition, and your TV does
	not react on the key press, remove the batteries out of the remote control
	and put them back again.
The remote of	< The infrared signals of the screen may influence the reception sensibility
connected equip-	of other peripherals.
ment does not	Solution: replace the batteries of the remote of other peripheral
function well	equipment.
No photo or music	< Verify if the source complies with a supported code.
play or in poor
quality
No stable or not	<Verify if you have selected the correct VGA mode in your PC.
synchronised VGA	See Connect a PC, p. 41.
picture	< Verify the connections between the TV and the PC.
No solution found	<Switch off your TV off and then on again once.
for your picture or	Never attempt to repair a defective TV yourself.
sound problem	Verify with your dealer or call a TV technician.
Red blinking led	< Unplug the mains cord for 10 seconds and insert it in again.

45