Audiovox PEQ-200 manual Operating Instructions, Input Connections

4.Input Connections

This crossover features low-level input capability and can accommodate two channels of low-level output from the car stereo, which is connected to the INPUT R/L jacks (item 12) on the rear panel as shown on the wiring diagram.

5.Output Connections

Connect the low-level output jacks from the PEQ-200 to the low-level inputs of the amplifier(s) in the system as shown on the wiring diagram. For 2-way systems, use the SUBWOOFER OUT R/L and HIGH PASS OUT REAR R/L jacks. For 3-way systems, use the

SUBWOOFER OUT R/L, HIGH PASS OUT REAR R/ L and HIGH PASS OUT FRONT R/L jacks.

OPERATING INSTRUCTIONS

1	3	4	5	6	7	8	9	10
	2							11
1 POWER INDICATOR

This LED indicator lights green when power is applied to the unit from a remote source, such as the radio and/or the vehicle ignition switch, and provided the remote terminal is connected to +12Vdc.

2PEAK INDICATOR

This LED indicator lights red when the equalizer input signal exceeds the input range, thereby causing saturation or over- loading to take place. The indicator will also light when the input signal itself is overdriven or clipped.

3MASTER MIN/MAX CONTROL

Rotate this control clockwise (MAX) or counterclockwise (MIN) to adjust the overall system volume after the source radio or amplifier volume output has been set to the desired level.

-7-