10 Troubleshooting
This section describes
Some problems you encounter with your TV can be corrected by consulting the following list: No picture, no sound
1
2
3
4 Check the signal source. No color
1
2
3 Try another program.
Remote control does not work
1
2
3 Main power is not connected. No picture, normal sound
1
2 Broadcasting failure may happen. Normal picture, no sound
1
2
3
4 Broadcasting failure may happen. Ripples on the picture
Usually caused by local interference such as cars, daylight lamps and hair driers. Adjust the antenna to minimize the interference.
Blank screen in VGA(PC) mode
Perhaps the TV can not recognize the resolution set by the PC. Change to the best resolution or other standard resolutions of the PC system.
Check the connections.
Set the PC refresh rate to 60Hz.
Snowy dots and interference
If the antenna is located in the fringe area of a television signal where the signal is weak, the picture may appear snowy.When the signal is weak, it may be necessary to install a special antenna to improve the reception.
•Adjust the position and orientation of the indoor/outdoor antenna.
•Check the connection of antenna.
•Fine tune the program.
•Try another program. Broadcasting failure may happen.
Ghost
“Ghosting” occurs when the television signal follows two paths. One is the direct path, the other is reflected from tall buildings, hills, or other objects. Changing the direction or position of the antenna may improve the reception.
Radio frequency interference
This interference produces moving ripples or diagonal streaks, and in some case, loss of contrast in the picture. Find out and remove the radio interference source.
28EN