2
3
Determine the correct diameter of bolt to use by carefully trying one bolt each from Bags 1 - 4 of the hardware kit. Do not force any of the bolts – if you feel resistance stop immediately and try a smaller diameter bolt. Attach the arms to the back of your display using the bolts identified in Steps 1 and 2 along with the corresponding Lock Washer (C, F, I, or L). 5
5
4 Mounting and adjusting
1With the help of another person, carefully lift your display and place it on mount. Place the display in the middle of the mount, and do not release the display until the mounting arms have securely hooked onto the crossbars. 6
6
A)If you are using the M4, M5, or M6 bolts (Bags 1, 2, and 3 respectively), you will also need to use the M6 Washers (O).
B)If you are using one of the longer bolts on a display with a curved or recessed back, you will also use a spacer (M or N). Use the smaller spacer (M) for M4 and M5 bolts and
the large spacer (N) for M6 and M8 bolts.
4Make sure all screws are secure, but do not
ETip
Use a longer bolt and spacer for displays with curved or recessed backs. Do not use the M6 Washer (O) if you are using the M8 Bolts (J or K).
2Move the safety tab located on each arm into position to avoid having the display accidentally lifted from the mount.This MUST be done in order to secure the display to the mount.
DNote
A cotter pin (included) is used to secure the arm into position OR a padlock (not included) can be inserted into one of the tabs to help prevent theft of your display. 7
7
3The cable management clips can be used to keep your power cord and other cables in order.
4