3Attach the arms to the back of your display using the bolts identified in Steps 1 and
2 and the corresponding lock washer (C, F, I, or L).You will need to use the M6 washers (O) if you are using the M4, M5, or M6 bolts. If your display has a curved or recessed back, you may also need to use a spacer (M or N).
4Make sure the screws are snug, but do not
5
ETip
Use a longer bolt and spacer for displays with curved or recessed backs. Do not use the M6 washer (O) if you are using the M8 Bolts (J or K).
BWarning
Insert the safety bar at the top of the mount to avoid having the display accidentally knocked off the mount.
2This MUST be done in order to secure the display to the mount.
DNote
A cotter pin (included) Is used to secure the arms to the mount OR a padlock (not included) can be inserted into the whole at the end of the saftey bar to help prevent theft of your display. 7
7
4Mounting and adjusting
1With the help of another person, carefully lift your display and place it on the wall plate. Do not release the display until the mounting arms have securely hooked onto the mount. 6
6
3
To adjust the tilt position, have one person hold the display in position while another person loosens the two tilt adjustment knobs located on either side of the wall plate. Once the knobs are loose, move the display to the desired angle.
8