Philips DVR2104 manual Power, Switch on and shut down, Safety, Install machine, Install HDD

Page 2

SAFETY PRECAUTIONS

Power

This video recorder is used on 110V-240V AC and connected to the ground. Confirm the voltage before using.

No using the machine for a long time, cut off the machine power supplies, and pulls out the plug from the AC outlet.

Caution

There are two modes of video output: one is BNC, and the other is VGA. They can be switched over via STEP key.The default output is BNC. Link the lines, power on

the Recorder, after the clock on VFD of the front block goes, press STEP key, then VGA will have output. Do not power on the monitor before powering on the recorder

Switch on and shut down

Check out the connection of system and power.

Normally stop recording and playing at first, then shut off the power.

Safety

This machine is an indoor equipment .In order to avoid the short circuit or danger, don’t put it in rain or damp environment.

If any solid or liquid entered, please shut off the power immediately, and ask the qualified person for technical check before restarting it.

It is a precise machine, so there is nothing inside user can mend himself. Anything wrong, please ask the qualified person or contact with the seller.

Stop playing or recording while replacing it, otherwise HDD or parts will be destroyed.

Install machine

Place the machine in a well-ventilated area. Make sure that there is enough space around the machine so that the vents are not blocked.

Do not place the machine nearby the source of heat, or in direct sunlight and wet environment.

Install HDD

Line jump: Before installing, find out the method of installation in HDD or the user guide, check the way is right or not.

Data line: check whether the link of date line is correct, the link of HD must be inserted into the bottom parallel.

1HDD Installation: Jump HDD as the master, plug IDE line into the first IDE slot near the front panel, connects the power cable and the data line with HDD then.

2 HDDs Installation: set one jump to the master and the other to the slave, connect the same team connect power line and material line to each one.

CLEAR HDD

When you use new HD, you should format the HD before the operation of clearing.

i

PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn

Image 2
Contents User Guide Safety PowerSwitch on and shut down Install machineAdvice Compression CharacteristicSystem mode Motion and detectEdition information SearchReplay VFD visionUpgrade Back upTable of Contents Display of running state System connection Front of the panel map Back panel and connection terminal Alert Record Record operationManual Motion DetectCombination record Play/ searchNormal recording Switch onShut down Alert recording Motion detection recording Schedule recordingPlay Multi-Function System PasswordSearching play HDD password Choice and format of discSystem setting DisplayRecord searching Quality with memory space & HDD with recording timeSystem setting Recording setting Page Alert setting Output it is alert output Schedule setting Backup Record searchingPage Detect System management Page Authority 20﹕43﹕43 Basic function display Display of running stateTime/date display Switch on Display Function of P.T. ZSpecification Main standard and parameterExternal dimension