PREPARATION
No supplied cables are used with these connections:
Please purchase ease ase the necessary cables at your local store. Use an HDMI cable with the HDMI logo (a certified HDMI cable).
High Speed HDMI cable (also known as HDMI category 2 cable) is recommended for the better compatibility.
Before you connect...
Be sure your antenna or other device is connected properly before plugging in the AC power cord.
Antenna Connection
Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit.
e.g.)
VHF / UHF analog or
DTV antenna
rear of this unit
RF coaxial cable
or
cable TV signal
*Once connections are completed, turn on the unit and begin initial setup. Channel scanning is necessary for the unit to memorize all available channels in your area. Refer to “Initial Setup” on page 17.
Note:
•If you have any question about the DTV’s antenna, visit www.antennaweb.org for further information.
•Depending on your antenna system, you may need different types of combiners (mixers) or separators (splitters). Contact your local electronics store for these items.
•For your safety and to avoid damage to this unit, please unplug the RF coaxial cable from the antenna input jack before moving the unit.
•If you did use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be more effective than a set top or inside antenna.
•To switch your reception source easily between antenna and cable, install an antenna selector.
•If you are not receiving a signal from your cable service, contact the Cable provider.
Connection to Cable Receiver or Satellite Box
Use an HDMI or an component video cable to connect the HDMI or the Component video Input jack of the unit to the HDMI or the component video output jack of the cable receiver / satellite box.
If you connect to the unit’s Component video Input jack, connect audio cables to the Audio L/R jacks below the Component video connector.
e.g.)
satellite dish
HDMI OUT |
|
| HDMI cable |
or |
|
|
|
AUDIO OUT | COMPONENT VIDEO OUT | ||
L | R | Y | Pb/Cb Pr/Cr |
SERVICE
TERMINAL
side or
rear of this unit
or
cable TV signal including PPV
ANT IN
RF coaxial
cable | (green) (blue) (red) |
|
STEREO |
PCM |
cable receiver / satellite box |
HDMI 2
(green) |
(blue) |
(red) |
component video cables
(red / blue / green) and audio cables
* You can also connect this unit to the cable receiver or satellite box other than the HDMI or the component video output jack because they might have different output jacks.
* Required cables and connecting methods of the cable receiver / satellite box, or the availability channel for the clear QAM may differ depending on the cable / satellite provider. For more information, please contact your cable /
12
satellite provider.
EN