6. Manual recording
General information
Use 'Manual Recording'to make a sponta- neous recording (for example, a programme cur- rently being shown).
If you want to start and stop a recording manual- ly, read the section 'Recording without auto-
matic switch-off'.
If you want to start a recording manually but have it stopped automatically, read the section 'Recording with automatic
Read the section 'Automatic recording from a
satellite receiver', if you want a recording to be controlled automatically by a satellite receiver.
Recording without automatic switch-off
1.Insert a cassette.
2.Use PROG P+ 
PROG P– or 0..9 to select the programme number you want to record, for example, 'P01'.
3.To start recording, press | REC I | . | |
4.To stop recording, press |
|
| . |
STOP | |||
Recording with automatic switch-off (OTR One-Touch-Recording)
1.Insert a cassette. |
|
|
|
|
| ||||||
2.Use |
|
|
|
| or |
| to select the | ||||
PROG P+ | PROG P– |
| 0..9 | ||||||||
programme number you want to record. | |||||||||||
3.Press |
| . |
|
|
|
|
|
| |||
REC I |
|
|
|
|
| ||||||
4.Each time you press |
|
|
|
| you will add 30 | ||||||
| REC I |
| |||||||||
minutes to the recording time.
5.To stop recording, press STOP
Preventing accidental erasing
All cassettes (except rental and
over important recordings (erasing), you can remove this security tab.
If you later decide to record on a protected cas- sette, simply cover the hole with adhesive tape or slide the tab to the right.
Lining up recordings (assemble cut)
When you add a further recording to a cassette, which already has a recording on it, a short blank (flicker) can appear between the old and the new recording or the picture itself can flicker. To help reduce these from occurring, proceed as follows:
1.Find the tape position of the old recording where you want to insert the new recording.
2.Look at the last minute of the old recording (playback).
3.Press STILL 2 at the tape position where the new recording is to go and press 
4.Now start recording as usual by pressing
on the remote control.
5.Stop recording with 
.
EN
11