Philips 14PV330/07 Installing Your TV-VIDEO Combi, Initial installation Allocating a decoder

aOpen up the battery compartment of your remote control and place the batteries in it as shown in the picture.

bClose the battery compartment.

cIf you have connected the aerial to the TV-VIDEO Combi, press the OK button.

’Automatic TV channel search’ starts. This picture will appear on the screen:

Some TV stations will send coded TV channels, that you can only watch when you use a decoder. You can connect such a decoder (descrambler) to your TV-VIDEO Combi. With the following function, the connected decoder will automatically be activated for the TV programme you want to watch.

aSelect the TV channel for which you want to use the decoder with the P p button on the TV-VIDEO Combi

or the number buttons 0-9on the remote control.

bPress the MENU button on the remote control. The main menu will appear.

c Select the line ’Installation’ with the BP r or AP q buton and confirm with the SqC button.

d Select the line ’Manual store’ with the BP r or AP q button and confirm with the SqC button.

Searching...

CHANNELS FOUND:

//////,,,,,,,,,,,,,,,,,,,,,

Wait until all TV channels have been found. This can take several minutes.

When ’autoinstall’is ready, ’Installation comp.’ will briefly appear on the screen.

DIf you have connected a decoder, you must install it as described in the next section.

DIf you have connected a satellite receiver, please read the section ’satellite receiver’.

e Select the line ’Decoder’ with the BP r or

AP q button.

ã Exit:

« press MENU

fSelect function ’ON’ with the DSr or SqC button. When you select ’OFF’, the function will be switched off.

gConfirm with the OK button.

hTo end, press the MENU button.

Your decoder has now been allocated to this TV channel.

iPress the MENU button again.

D If you have programmed a recording (TIMER), a wake-up timer or a sleep-timer, you can’t select the function ’Manual store’.