Philips VRA231AT owner manual VCR Display Panel

Page 21

VCR Display Panel 21

VIDEO

AUDIO

POWER

VCR/TV

Cassette Compartment

Insert a tape here.

	PLAY
REW	F.FWD
	STOP
	EJECT
	PAUSE
REC/OTR

CHANNEL

PWR.(power) Light

This light appears when the power is on.

Cassette-Inside Light

This light appears when there is a tape in the VCR.

VCR Light

This light appears when the VCR is in VCR position. This light does not appear when the VCR is in TV position.

REC(ord) Light

This light appears during a record- ing. It flashes when a recording is paused.

Timer Light

This light glows when the VCR is turned off to set a timer recording or during a One- Touch Recording. It flashes if the power is off for a timer recording, but there is no tape in the VCR. It flashes when all timer recordings are finished.

Clock Display

The current time appears here when the clock is set. If the clock is not set, -:-- will appear here. PM will appear on the display, but AM will not.

Image 21

Contents VRA231AT For Customer Use Dear Philips Magnavox product ownerThis bolt of lightning indi- cates uninsulated material Model No Serial NoFeatures Safety PrecautionsIntroduction Table of Contents Before Using Your VCR Disconnect the antenna or cable from your TV Hookups Without a Cable Box / Direct Broadcast SystemPlug in the TV and the VCR CH3 CH4Hookups With a Cable Box / Direct Broadcast System ConnectionsRecording/Viewing Any Channel Connect a Cable signal to the VCR’s ANTenna in Jack Cable SignalRecording One Channel/Watching Another Select the channel you want to watch at the Cable Box/DBSHookups With a Stereo TV Turning on Your VCR Press the VCR button, then press the Power button2Turn on the TV Press the Menu button. The display shown below will appearPress the VCR button Press the Menu button Automatic Channel SetupAdding/Deleting Channels Automatic Channel Setup cont’dPress the STATUS/EXIT button once or twice to exit Reviewing Memorized ChannelsSetting the Clock Daylight-Saving Time Press the VCR button Language Selection Eject Button Remote Control Buttons VCR Button Menu ButtonRemote Control Buttons cont’d Status Display example only On-Screen Status DisplaysIf you select Status ON, then select Counter only on If you select Status ON, then select Counter only OFFVCR Display Panel Front Panel Rear Panel Playing Read and follow the steps below to play a tape1Turn on the TV 2Insert a tape in the VCR Insert a tape with its record tab intact in the VCR RecordingIf the VCR light appears on the display panel, go to . If VCR light does not appear, press the VCR/TV button onceVCR light will disappear from the VCR’s display panel Recording One Channel/Watching AnotherOTR CH12 One-Touch RecordingDaily Timer RecordingInstructions continue on Timer Recording cont’dTape Speeds Press the STATUS/EXIT button. Program WAS COMChecking or Cancelling Timer Recordings Setting Up the VCR Plus+ Programming System ChannelsCall Letters Examine the lists on Setting Up the VCR Plus+ Programming System cont’dTimer Recording with the VCR Plus+ Programming System See page 42 for more hints Should appear on-screen brieflyRF coaxial cable Rerecording Tape DuplicationPress the F.FWD/B button so that on appears beside Repeat PlayButton to reset the real-time counter to zero Real-Time Counter MemoryWhile the status display is on-screen, press the Clear Forward and Reverse Searching SP/LP/SLP Special Effects PlaybackSuper High Speed Searching LP/SLP Viewing a Still PictureAutomatic Operation Features Cable Box/DBS Output Channel 03 or GlossaryHelpful Hints Helpful Hints cont’d Specifications Model # Serial # Limited WarrantyIndex Page Supplied Accessories