NOTES ABOUT THE REMOTE CONTROL
Battery installation | Remote control operation range |
English
Since the remote control will be used for many of this unit’s control operations, you should begin by installing the supplied batteries.
1.Turn the remote control over and remove the battery compartment cover by sliding it in the direction of the arrow.
2.Insert the batteries (AA, R6,
3.Close the battery compartment cover.
Remote control sensor
1 |
|
|
|
|
|
| Within approximately |
3 |
|
| 6 m (19.7 feet) |
|
|
| |
| 30 |
| ° |
2 | ° | 30 | |
|
| ||
|
|
|
Battery replacement
If you notice that the remote control must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones.
Notes
●Use AA, R6,
●Be sure the polarities are correct. (See the illustration inside the battery compartment.)
●Remove the batteries if the remote control is not used for an extended period of time.
●If batteries leak, dispose of them immediately. Avoid touching the leaked material and contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.
Notes
●The area between the remote control and the main unit must be clear of large obstacles.
●Do not expose the remote control sensor to strong lighting, in particular, an inverter type fluorescent lamp; otherwise, the remote control may not work properly. If necessary, position the main unit away from direct lighting.