Telex sc-600 System Configuration, Power Supply, 110/220 Volt Operation, Front View

System Configuration

Figure 2 illustrates the typical system configura- tion using the SC-600.

SPECIAL NOTE: In any system, unused splitter outputs should be terminated with a 50 ohm “dummy load”. See the accessories listing at the end of this manual.

Power Supply

The SC-600 is equipped with an internal 110/220 VAC @ 50/60 Hz power supply that is rated with a minimum output of 15 VDC at 1.3 amps. A standard IEC320 power input connector is provided to reduce external wiring.

POWER ON/OFF LED

Telex R SC - 600

UHF ANTENNA SPLITTER/COMBINER

Front View

TRANSMIT	TRANSMIT	DC	RECEIVE
		OUTPUT	RECEIVE
ANTENNA		110/220 VAC INPUT	ANTENNA
		FUSE:	F 1.5A 250V

FUSE BOX

POWER ON/OFF

110/220 VAC INPUT

Rear View

Figure 1

Front and Rear View

110/220 Volt Operation

Operation in either 110 VAC or 220 VAC is easily achieved. If the voltage indicated on the fuse box does not match the voltage you are operating in, the fuse must be changed. Open the fuse box door to remove and rotate the fuse holder. Make sure the voltage indicted, when the fuse box door is closed, matches your operation voltage. refer to Figure 1.

-2-