Manitowoc Ice K00333, K00334 installation instructions Bottom Half Top Half

3.Install your precut wire shelf pilasters to the top half of your cabinet above the tray slide pilaster. Note: when installing your wire shelf pilaster above the tray slide pilaster on the 2-door, the top of the pilaster closest to the drain tube must be cut off to an overall length of 17.625” for clearance. The thumbscrews should be used to lock the shelf pilasters in place at the top of the cabinet.

4.(Use steps 4 and 5, when installing on top half.) Install your precut wire shelf pilasters to the bottom half of the cabinet first.

5.Install your tray slide pilasters using the bottom slotted holes on the pilaster, as shown in Fig. 4. Press in and down to lock into place. Use the thumbscrews to lock into place.

6.When installing a full cabinet door of tray slides, always start with the bottom and work up, making sure the top and bottom pilasters are flush where they meet.

7.Hang tray slides on tray slide pilaster with tap openings facing down (see Fig. 1). Insert shelf clips at desired levels. There should be no less than a minimum of 9” between the top wire rack or tray slide and evaporator drain pan.

NOTE: The 2-door kit is K00334. When installing this kit, the notched pilaster goes around the drain tube on the top back wall. The foam tape should be installed between the tray slide pilaster (on the pilaster) and the back wall of the cabinet (see Fig. 2).

Mounting Stud

		Tray Slide
Cabinet
Foam Tape	Fig. 1	Tray Slide Pilaster

Drain	Mounting Stud
	Bottom Half
Tube
	Inside Set of
	Slots are used
	for Left/Right
	Front Corner
	Location

Fig. 2	Fig. 3	Fig. 4
	Bottom Half	Top Half

Mounting Stud

Top Half

8010553 Sheet 2 of 2 Rev. 04/01/99