Test Mode, While the game is playing

12. Test Mode

While the game is playing:

-Press test button once plays a sound but doesn’t affect game play.

-Press and hold test button for 2 seconds stops game-play, clears credits and resets game.

While the game is in attract mode:

-If all sensors are operational and there are no errors

-The display attract show lights every segment in a figure eight order

-If there are sensor problems detected the display will show a letter code corresponding to the bad optical sensor

•Press Test button once to test lights, optical sensors, prize sensor, and push button.

This enters “Segment display Test mode”

Segments of the Display will light while the corresponding optical sensor is blocked.

-Pressing push button will initiate check optical sensor sequence and then return to test mode segment display, flashing all segments of bad optical sensors.

-Sements of the Display will flash if there was a problem detected with the corresponding optical sensor.

AA = Nose Open sensor * B = Nose Close sensor

F				B * C = Head Up sensor

GD = Head Down sensor

EC * E = Elephant Left sensor F = Elephant Right sensor

D * G = Elephant Home sensor

ALL SEGMENTS = Prize sensor with audible tone

Note: *=Imperative optical sensor

- Pressing test button again enters Nose Motor Test - Display will read “1”

Nose motor will then move from closed to open until test button, or either volume button is pressed

-Press Volume Up or Volume Down buttons to initiate manual nose motor movement test Press Volume Up button to open nose.

Press Volume Down button to close nose.

Note: Optical sensor segments will light when optical sensor is blocked.

-Pressing Test button again enters Head Up / Down Motor Test - Display will read “2” Head motor will then move from Up to Down until test button or either Volume button is

pressed.

-Press Volume up or Volume Down buttons to initiate manual head motor movement test Press Volume up botton or Volume down button to move head up and down. Note: Optical sensor segments will light shen optical sensor is blocked.

-Pressing test again enters the Body Left / Right Motor Test - Display will read “3” Body Motor will then move left to right and home until test button or either volume

button is pressed

-Press Volume up or Volume down buttons to initiate manual body motor movement test Press Volume up button to move body to its left.

Press Volume down button to move body to its right.

Note: optical sensor segments will light when optical sensor is blocked