Blaupunkt VA4100 manual Speaker Outputs Fuses, Power Connections & Trigger Line

CONNECTIONS & CONTROLS

SPEAKER OUTPUTS	FUSES	POWER
		CONNECTIONS &
		TRIGGER LINE

English

SPEAKER OUTPUTS - The amplifier is connected to appropriate impedance speakers via these leads. It is IMPERATIVE that these leads NOT be connected or touch the vehicle chassis in any way or the amplifier will be damaged. The (+) and (-) leads of the amp are in no way inter- connected to one another. Also, NONE of the leads can touch each other, touch ground, or touch +12V or damage may occur to the amp or vehicle.

FUSES - These fuses are only for catastrophic situations should the amplifier begin to self-destruct or incur installation situations where gross amounts of current are being required from the amp beyond its design limits. Although another fuse should be installed inline with the high power line at the battery, these amplifier mounted fuses MUST remain in the circuit to protect the amplifier.

POWER CONNECTIONS & TRIGGER LINE

+12v - A high current line run direct from the batter is highly recommended to insure adequate current and voltage. This line MUST be run through a dedicated fuse of some kind and this fuse should be located immediately next to the power source. This in-line fuse is used to protect the vehicle should a short to chassis occur.

+12V Terminal

Connect directly to the vehicle battery (+) terminal with 10 gage wire (minimum)

	NOT SUPPLIED
To Battery	Fuse or
Terminal	Circuit Breaker
10 Gage	Battery
Wire	Terminal
	Adapter

Ground Terminal

Connect to a good chassis ground. The ground connection should be clean, unpainted metal to provide a good electrical connection.

TRIGGER - This line tells the amp to turn on and is remotely switched from the radio which normally provides an amp “trigger” output. This line is required to go “high” (+12V) to turn on the amp. If this line is not available, use the power antenna line trigger which is normally available in most radios.

GROUND - This is the high current ground connection to the chassis of the car. It should be fastened to a clean ground connection in the vehicle, capable of handling high current loads. This wire should be no

10 Gage

Wire

Sheet

Metal

Screw

Ring

Connector

Drill 1/8” hole

in chassis

sheet metal

longer than 3 feet (1 meter).

BLUE DOT LIGHT INDICATOR ON THE TOP OF THE AMPLIFIER (not shown above)

POWER ON - This light will turn on when the amplifier receives a +12V turn-on signal from the radio. If the amp is properly wired, but the light does not turn on, there may be a short circuit condition that the amp is protecting itself from.

PROTECTION LED - This light flashes if the amplifier senses a severe problem, such as a speaker short circuit.

Trigger Terminal

Connect the radio power antenna lead from the receiver to the trigger terminal. This turns the amplifier on whenever the receiver is turned on.

			Butt
	To Receiver		Connector
		(not supplied)
	Power
	Antenna Lead
18-20 Gage
Wire

– 8 –

www.midwestelectronics.com