Invacare operating instructions Installing The Ventilator Tray Hanger

Installing The Ventilator Tray Hanger	EXISTING
Bracket Onto The Ventilator Tray	Screw
(FIGURE 2)

NOTE: The plastic washer is not shown.

1.Align the two (2) mounting holes in the ventilator tray hanger bracket with the two (2) mounting holes in the FRONT of the ventilator tray.

2.Secure the ventilator tray hanger bracket to the ven- tilator tray using two (2) 1/4 - 20 x 3/8-inch button head screws and self locking nuts. Securely tighten.

Self Locking Nuts

Ventilator Tray

Hanger Bracket

		Roller
EXISTING
Self
Locking		Chair
Nut	Mounting Hole	Frame
Ventilator Brace

1/4 20 x 3/8-inch

MountingButton Head Screws Holes

FIGURE 2 - INSTALLING THE VENTILATOR TRAY HANGER BRACKET ONTO THE VENTILATOR TRAY

NOTE: Only one side of the ventilator brace attachment shown for clarity.

FIGURE 3 - INSTALLING THE VENTILATOR BRACE

ONTO THE CHAIR FRAME

Installing The Ventilator Tray Onto The Chair Frame (FIGURE 4)

1.Positionthetwo(2)tubeclampsonthe LOWERbrace of the chair frame by firmly grasping each tube clamp, and bending it around the LOWER brace of the chair frame.

NOTE: Be sure the open ends of the tube clamps are facing TOWARD the UPPER brace of the chair frame.

Installing The Ventilator Brace Onto The Chair Frame (FIGURE 3)

1.Remove the self locking nut and plastic washer from the screw securing the roller to the chair frame.

NOTE: Save the EXISTING self locking nut for reuse when installing the ventilator tray. Discard the plastic washer.

2.Align the mounting hole in the ventilator brace with the EXISTING screw securing the roller to the chair frame.

3.Secure the ventilator brace onto the EXISTING screw using the EXISTING self locking nut. Securely tighten.

4.Repeat STEPS 1 - 3 for the opposide side of the ventilator brace.

2.PositiontheventilatortraybetweentheMIDDLEbrace and the LOWER brace of the chair frame, making sure the ventilator brace fits securely in the ventilator tray hanger bracket.

3.Align the two (2) MIDDLE mounting holes of the ven- tilator tray with the mounting holes in the two (2) tube clamps on the LOWER brace.

4.Secure ventilator tray to the two (2) tube clamps on the LOWERbraceusingtwo(2)5/16 - 24 x 1-1/2-inch hex headscrewsandselflockingnuts. HandtightenONLY.

5.Positiontheclampsaddleundertheventilatortrayhanger bracket AND the ventilator brace, making sure the two

(2) mounting holes in the clamp saddle align with the two mounting holes in the ventilator hanger bracket.

6.Threadtwo(2)1/4 -20 x1-1/2-inchbuttonheadscrews throughonesideoftheventilatorhanger,theclampsaddle and the other side of the ventilator hanger, and secure using two (2) self locking nuts. Hand tighten ONLY.

2