B-SERIES TROWEL — INSTRUCTIONS
General Instructions
Set the throttle lever to the idle position by pushing it away from the operator’s position towards the engine (counter clockwise from the top- Step 1). Loosen the screw that crimps the throttle cable to allow free movement of throttle cable (Step 2).
STEP 1
STEP 4
Connect the throttle cable to the engine. Keep in mind there should be a piece of wire installed on the machine to show you where to route the throttle cable. When connecting the cable housing, make sure that no more than 1/4" (6.4mm) of the cable housing protrudes past the housing clamp on the engine (Step 4). After the cable has been installed on the engine, tighten the clamp on the throttle control, operator position of the handle to lock the throttle cable at the proper length.
These are general instructions. Installation of the throttle cable may vary for different engine configurations. Please look for more detailed instructions inside the box containing the handle. These more detailed instructions should provide adequate guidance for installing.
STEP 2
STEP 3
On Robin engines, the hook on the engine end of the throttle wire must be removed. Make the cut as shown (Step 3). The rest of the engine will not require this modification to the throttle cable.
PAGE 10 —