Husqvarna K750 manual Fuel filter, Air filter, Adjusting the idle speed

Page 18

MAINTENANCE

Adjusting the idle speed

Adjust the idle speed using the T screw. When an adjustment is necessary, first turn the screw clockwise until the blade starts to rotate. Now turn the screw anti-clockwise until the blade stops rotating.

T

Rec. idle speed: 2700 rpm

WARNING! If the idle speed cannot be

!adjusted so that the cutting attachment stops, contact your dealer/service workshop. Do not use the machine until it has been correctly adjusted or repaired.

Fuel filter

The fuel filter sits inside the fuel tank.

The fuel tank must be protected from contamination when filling. This reduces the risk of operating disturbances caused by blockage of the fuel filter located inside the tank.

The filter cannot be cleaned but must be replaced with a new filter when it is clogged. The filter should be changed at least once per year.

Air filter

Air filters must be regularly cleaned to remove dust and dirt in order to avoid:

Carburettor malfunctions

Starting problems

Loss of engine power

Unnecessary wear to engine parts

Excessive fuel consumption.

The air filter system consists of an oiled foam plastic filter (1) and a paper filter (2):

2

1

1The foam plastic filter is easily accessible under the filter cover A. This filter should be checked weekly and replaced if necessary.

A

B

In order to obtain a good filtering effect, the filter must be replaced regularly or cleaned and oiled. A special HUSQVARNA oil has been produced for this purpose.

Remove the foam plastic filter. Wash the filter well in tepid soapy water. After cleaning, rinse the filter well in clean water. Squeeze out and allow the filter to dry. NOTE! High pressure compressed air can damage the foam.

Put the filter in a plastic bag and pour the filter oil over it. Knead the plastic bag to distribute the oil. Squeeze the excess oil out of the filter inside the plastic bag and pour off the excess before fitting the filter to the machine. CAUTION! Never use common engine oil

2The paper filter is accessible under cover B. This filter must be replaced/cleaned when the engine's power drops or each month. The filter is cleaned by shaking. Note that the filter must not be washed. NOTE! High pressure compressed air can damage the filter.

An air filter that has been in use for a long time cannot be cleaned completely. The filter must therefore be replaced with a new one at regular intervals. A damaged air filter must always be replaced.

IMPORTANT INFORMATION

Poor maintenance of the air filter will cause carbon build-up on the spark plug and abnormal wear to engine parts.

18 – English

Image 18
Contents K750 KEY to Symbols Key to symbolsContents What is WHAT? What is what on the power cutter?Safety Instructions Steps before using a new power cutterPersonal protective equipment Vibration damping system Machine′s safety equipmentStop switch MufflerGuard for the blade Checking the blade guard General safety precautionsFuel safety Transport and storageCutting Basic safety rulesGeneral working instructions GeneralHow to avoid kickback Cutting blades GeneralAbrasive discs Diamond blades for dry cutting Diamond bladesDiamond blades for wet cutting MaterialFitting the cutting blade AssemblyChecking the drive axle and flange washers Guard for the bladeK750 Fuel HandlingFuel K750 OilGuardFueling Disconnection function for OilGuardStarting and Stopping Starting and stoppingReplacing the drive belt MaintenanceTensioning the drive belt Belt pulley and clutchAdjusting the idle speed Fuel filterAir filter Tensioning the recoil spring StarterChanging a broken or worn starter cord Changing a broken recoil springMuffler Spark plugCooling system Fitting the starterWeekly maintenance General maintenance instructionsDaily maintenance Monthly maintenanceTechnical Data Technical dataCutting equipment Federal Emission Control Warranty Statement Your Warranty Rights and Obligations1150900-95 ´z+Rz¶5C¨ ´z+Rz¶5C¨
Related manuals
Manual 4 pages 16.39 Kb Manual 24 pages 53.49 Kb