X23_50 full hd english manual paPage 1 5. 10. 2009 10:26:17
User Guide
Attaching/Detaching the Stand & Wall mounting
Attaching the Stand
Base of stand
1)Insert the TV into the stand
2)Twist the TV into the CLOSE position until it clicks into place at 45 degrees
IMPORTANT— BEFORE DRILLING ANY HOLES IN THE WALL ENSURE YOU ARE NOT DRILLING WHERE THERE COULD BE ANY ELECTRIC WIRES, WATER OR GAS PIPES
THIS TV REQUIRES A VESA
100 WALL MOUNT, OR EQUIVALENT
100
To remove the stand
1)Remove base as shown opposite
2)Remove the four screws highlighted below
3) Remove the two screws in the neck of the stand.
4) The stand will now come off
Wall Mounting the TV.
1)Remove the four screws highlighted below.
2)The wall mount can now be easily attached to the mounting holes on the rear of the TV. These holes are indicated in the picture
Important – If wallmounting this TV, only use the screws already provided in the wallmounting holes. Using other screws which are longer could cause irreparable damage to internal parts.
9