Stow manual Stow T-20H Pump Components

Page 13

STOW T-20H — PUMP COMPONENTS

Figure 2 shows a typical application using the STOW T-20H trash pump. Please note that this pump is intended for the removal of clean water and water containing some debris and solids. Maximum size of solids should not exceed 1 inch (25 mm) in diameter. DO NOT set strainer on bottom of water bed. Placing the strainer above the water bed will prevent the pump from drawing in excessive amounts of sand and foreign debris.

Figure 2. STOW T-20H Pump Application

1.

Pump – The STOW Model T-20H is 2-inch trash pump

 

used in general de-watering applications. Typical

 

dewatering applications consist of manholes, septic tanks,

 

fast and slow seepage ditch water, silt water, mud water

 

and muck water.

2.

Fill Cap – Prior to operation, the pump casing should be

 

filled with water.Remove this cap to add water to the pump.

 

After the initial prime, a sufficient amount of water will be

 

retained in the casing so that the operator will not need to

 

re-prime later.

 

If the casing is dry or has insufficient water, the pump will

 

have difficulty in priming which could lead to premature

 

mechanical seal wear thus causing damage to the pump.

3.

Discharge Port – Connect a 2-inch discharge hose to this

 

port.

4.

Worm Clamp – Used to secure the hose to the inlet and

 

outlet ports on the pump. Use two clamps to secure the

 

hose on the inlet side of the pump.

5.

Discharge Hose – Connect this flexible rubber hose to

 

the discharge port on the pump. Make sure that the hose

 

lays flat and is not kinked. Use only recommended type

 

discharge hose. Contact Multiquip parts department for

 

ordering information.

6.

Suction Port – Connect a 2-inch inlet hose to this port.

 

Use two worm clamps to secure the hose.

7.

Suction Hose – Connect this flexible rubber hose to the

 

suction port on the pump. Make sure that the hose lays flat

 

and is not kinked. Use only recommended type suction

 

hose. Contact Multiquip parts department for ordering

 

information

8.

Clean-out Cover Handles – To gain access to the pump's

 

clean-out area, grip both handles, then pull to remove cover.

 

Make sure both locking knobs have been released before

 

attempting to remove clean-out cover.

9.

Drain Plug – Remove this plug to drain water from the

 

pump.

10. Clean-out Cover – Remove cover to gain access to the clean-out area.

11. Locking Knobs– Turn both knobs clockwise to secure clean-out cover, turn counter-clockwise to release cover.

12. Strainer – Always attach a strainer to bottom side of the suction hose to prevent large objects and debris from entering the pump. Strainer should be positioned so that it will remain completely under water.Running the pump with the strainer above water for long periods can damage pump.

STOW T-20H TRASH PUMP — PARTS MANUAL— REV. #0 (05/29/03) — PAGE 13

Image 13
Contents Model T-20H Trash Pump 2 -STOW T-20H Trash Pump Parts Manual REV. #0 05/29/03 Heres HOW to GET Help Stow T-20H Table of Contents When ordering parts Please supply the following information Parts Ordering ProceduresStow T-20H Safety Message Alert Symbols Accidental Starting Rules for Safe Operation General SafetyRules for Safe Operation Specifications Pump Specifications Engine STOWT-20H General Information Stow T-20H Pump Components Initial Servicing Stow T-20H Basic EngineStow T-20H PRE-INSPECTION Engine Read safety instructions at the beginning of manual Stow T-20H PRE-SETUP PumpStow T-20H Initial START-UP Engine Stow T-20H Initial START-UP Engine Stow T-20H Trash Pump Parts MANUAL- REV. #0 05/29/03 Pump Vacuum Test Stow T-20H Maintenance PumpStow T-20H Maintenance Pump Engine Maintenance Schedule Stow T-20H Maintenance EngineStow T-20H Maintenance Engine Pump Storage STOWT-20H Preparation for Long -TERM StorageStow T-20H Trash Pump Parts MANUAL- REV. #0 05/29/03 Troubleshooting Engine STOWT-20H Troubleshooting ENGINE/PUMP Items Found In the Remarks Column STOWT-20H Explanation of Code in Remarks ColumnQty Description Stow T-20H Suggested Spare PartsStow T-20H Pump Assy Pump Assy 32 -STOW T-20H Trash Pump Parts Manual REV. #0 05/29/03 Part Name QTY Honda GX160K1TX2 Engine AIR Cleaner Dual Assy GASKET, Elbow Honda GX160K1TX2 Engine Camshaft Assy Part Name QTY. Remarks Honda GX160K1TX2 Engine Carburetor Assy Part Name Honda GX160K1TX2 Engine Control Assy ARM, Governor Honda GX160K1TX2 Engine Crankcase Cover Assy GASKET, OIL Filler CAP Honda GX160K1TX2 Engine Crankshaft Assy Crankshaft T-TYPE Honda GX160K1TX2 Engine Cylinder Barrel Assy Includes Items W/ # Honda GX160K1TX2 Engine Cylinder Head Assy CLIP, Valve Guide Honda GX160K1TX2 Engine FAN Cover Assy COVER, FAN *NH1* Black Honda GX160K1TX2 Engine Flywheel Assy FAN, Cooling Honda GX160K1TX2 Engine Fueltank Assy JOINT, Fuel Tank Honda GX160K1TX2 Engine Ignition Coil Assy Coil ASSY., Ignition Honda GX160K1TX2 Engine Muffler Assy Muffler Honda GX160K1TX2 Engine Piston Assy Piston + Rings Assy Honda GX160K1TX2 Engine Recoil Starter Assy REEL, Recoil Starter 64 -STOW T-20H Trash Pump Parts Manual REV. #0 05/29/03 Honda GX160K1TX2 Engine Gasket KIT Assy Honda GX160K1TX2 Engine Labels Assy LABEL, Caution Effective October 1, 2002 Terms and Conditions of Sale Parts Stow T-20H Trash Pump Parts MANUAL- REV. #0 05/29/03 Please have the Model and Serial Number ON-HAND When Calling