RF-Link Technology ABM-4161 user manual Camera Setup Power Supply Loading the Batteries See Fig

Page 4

Set Up

Camera Setup

1.1Power Supply

Loading the Batteries (See Fig. 3)

1.Loosen the screw on the bottom of the camera by using a screw driver. (Step 1)

2.Open the battery compartment cover. (Step 2)

3.Insert 4 AAA-size batteries (follow the plus (+) and minus (-) signs inside the battery compartment). (Step 3) Note : The camera uses either 4 AAA batteries (alkaline battery recommended) or AC power current.

4.Close the battery compartment cover, and make sure it is locked securely.

Note 1: Do not mix old batteries with new ones.

Note 2: Remove the batteries from the camera if you do not plan to use it for a prolonged period of time. 5. Slide the POWER switch to the ON position. The LED on the camera (red light) will light up. (Step 4)

Note: When battery power is sufficient, the light is constantly red; when it is low, the LED light will start blinking.

Using AC Power (See Fig. 4)

1.Plug one end of the power adapter into a wall outlet and the other end into the bottom of the camera. (Step 1, 2)

2.Slide the ON/OFF switch to the ON position. The LED on the camera (red light) will light up. (Step 3)

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents RF-Link Package Content Product LayoutCamera Fig Camera Setup Power Supply Loading the Batteries See Fig Using AC Power See FigFine Tuning See Fig Night light See FigMonitor Setup Power Supply Loading the Battery See Night visionBrightness Setting See Fig VOX voice-operated transmission Function See FigIf the signal is poor, or there is interference You dont get a signal at allCare and Maintenance
Top Page Image Contents