4GETTING STARTED
5Press [ 
] to turn the Parent Unit on.
•Before first use, or if it has been out of use for a long time, the Parent Unit will need to be charged for
For the Baby Unit
1In the event of a power failure, your Baby Monitor can switch to battery power. It is therefore recommended that you insert
2Remove the battery cover on the back of the Baby Unit by pressing and sliding it down.
Insert 3 alkaline batteries of the |
|
type AA (not provided) as marked | Slide |
| |
on the unit and close the cover |
|
again. Do not use rechargeable |
|
batteries in the Baby Unit. |
|
3Plug the power cord into the power input at the side of the Baby Unit and plug the adaptor plug into a mains power socket.
4Press [ 
] to turn on the Baby Unit.
•The Baby Unit should be placed about 1 metre to 1.5 metres away from the baby's cot on a flat surface. Never place the Baby Unit inside the cot, bed or playpen. Make sure the unit, cords and mains adaptor are out of reach of the baby and other young children. Never place either Unit on antique or polished surfaces (as slippage or scuffing may occur). The unit may cause harm if it falls onto baby or other young children.
Note:
If you place the Parent and Baby units too close together you will hear a high pitched noise called "feedback", this is normal. The units are designed to be located in separate rooms.
To prevent feedback, do not take the parent unit into the nursery/baby's room.