Unisar Prenatal Heart Monitor manual Instructions, Troubleshooting

INSTRUCTIONS

For Listening (Please refer to diagrams on P. 10-11):

1.Make sure the foam cover is in place on the listening cone.

2.Remove battery compartment door and install a new 9-volt alkaline battery (not included), keeping the ribbon under the battery and exposed for easy removal. Press battery forward and down. Be sure to use a new battery as an old one will severely interfere with the performance of your Monitor.

3.Insert the headphone plug into either jack on the Monitor.

4.Turn on the Prenatal Heart Listener ® using the ON/OFF volume control switch. The red LED will light to indicate the unit is in the ON position.

5.Use the Monitor on bare skin in a quiet room.

6.Hold the cone to your stomach or lower back (near your kidneys) and press and hold down the activation button. Adjust the volume to optimize the listening level and amplification. Start with a low to moderate setting to avoid static.

7.If you do not hear the heartbeat, release the activation button and gently move the Monitor one inch at a time to different places until you find the best position for listening to your baby’s sounds. Start two inches below and a little to the right of your belly button. Always release the activation button when you are moving the Monitor across your stomach or back.

For Recording:

1.To record these sounds plug the L-shaped end of the recording cable into either jack of the Monitor and the straight end into the line input of your tape recorder. (Some portable recorders do not provide this input.)

2.Position the Monitor on your bare skin so you can hear the sounds you wish to record.

3.Adjust the recording level on your tape recorder if necessary.

4.Hold the Monitor very still and begin recording.

8

5.When you record your own heartbeat to play to your newborn, reduce the volume as your heartbeat is much louder than you unborn baby’s. We suggest making a 30-minute recording of your heartbeat.

TROUBLESHOOTING

If your unit is not working properly, please check the following:

1.Activation button is not held down during listening.

2.Volume control is too low.

3.Battery and/or headphone connection is not complete.

4.Foreign matter is in the listening cone.

5.Weak battery (ON/OFF LED signal will be dim).

6.Feedback/squealing noises – turn down the volume and/or move the headphones further away from the Monitor. Press activation button only when the Monitor is against your body.

7.Foam cover is not in place on the listening cone.

The Prenatal Gift Set is a Personal Care Product

and cannot be returned to the retailer. All exchange and refund

requests should be directed to our Help Desk.

If you are having difficulty, have questions, or need assistance, call our Help Desk toll free at 1-888-232-6476 Mon-Fri from 9:00AM-5:00PM EST

Please read on

9