SC484_book.qxd
ENGLISH 9
Beltclip
Connecting to the Parent Unit
1 Slide the wider side of the clip into the small rectangular recess on the back of the Parent Unit. Make sure the pins on the underside are above the circular recess.
2 Press the clip downwards until it clicks in position.
Disconnecting from the Parent Unit
1 Place a flat screwdriver under the belt clip as indicated.
2 | Gently press the screwdriver's point against the visible pin (1) in the |
(1) | circular recess. |
| |
3 | Press the pin until the clip comes off. |
Note: Do not use excessive force when pressing the pin! This could damage the clip and you might injure yourself with the screwdriver.
Monitoring your baby
Switching on the units
1Position the Baby Unit at least one metre away from your baby. Never place the Baby Unit inside the baby ’s bed or playpen.
2 Press and hold the A button (5) on the Baby Unit to switch on the Baby Unit.
3 Press and hold the A button (23) on the Parent Unit to switch on the Parent Unit.
> All lights light up for 2 seconds and then turn off again.
>The DECT SYSTEM LINK lights (3 and 15) of both units light up orange then start blinking (green).The units now search for connection.
>The DECT SYSTEM LINK lights (3 and 15) of both units light continuously (green) when the units have established connection. You can now monitor your baby.
•To switch off the units again press and hold the A buttons (5 and 23).
>The units will beep when they are switched off.
Note:The Parent Unit beeps when it is (accidentally) switched off while monitoring.