NOTE: The “!” symbol indicates that this step is easier if you have another person assist you.
STEP 1 - PICTURE 1: Attach the HANDLE (A) to the HANDLE FRAMES (B) using TWO SHORT SCREWS (C).
!- STEP 2 - PICTURE 2: Decide if you want the handle attached in front of the carriage or behind it (it can be removed and reattached, by an adult, in the other position at any time).
Attach the TWO HANDLE FRAMES (B) to the WICKER BODY (D) using FOUR LONG BOLTS (E), FOUR WASHERS (F), and FOUR CAP NUTS (G). The bolts with washers go through the holes inside of the wicker body, and then secure the parts together on the outside of the body using the cap nuts.
PICTURE 1 | PICTURE 2 |
A
BBD
!- STEP 3 - PICTURE 3: Attach the TWO CHASSIS FRAMES (H) to the WICKER BODY (D) using FOUR LONG BOLTS (E), FOUR WASHERS (F), and FOUR CAP NUTS (G). The bolts with washers go through the holes inside of the wicker body, and then secure the parts together on the outside of the body using the cap nuts.
STEP 4 - PICTURE 4: Attach the TWO AXLES (I) to the underside of the CHASSIS FRAMES (H) using FOUR SHORT BOLTS (J), and FOUR CAP NUTS (G). The bolts go through the bottom, and then secure the parts together on the top using the cap nuts. The axles face the inside.
PICTURE 3 | PICTURE 4 |
D
II
H H
AXLES FACE
THE INSIDE
Page 3 of 4 | 1.0/0407/TG |