ASSEMBLY continued
3Secure Wheel to Axle as shown:
•Push Connector onto Axle with Ribs facing in.
•Slide Wheel onto Axle and push into Connector.
•Slide Wheel Retainer onto end of Axle. Make sure large end of Wheel Retainer is towards Wheel. Wheel Retainer should snap into groove on end of Axle.
•Snap wheel Retainer Cap over Wheel Retainer.
•Line up Hub Cap tabs with slots in Wheel and snap Hub Cap in place.
Ribs
Axle
Hub |
|
| Connector | |
Cap |
|
| ||
Wheel |
| Brake | ||
|
| Lever | ||
Retainer Retainer | Wheel | |||
Bracket | ||||
| Cap |
| ||
|
|
| ||
CAUTION:
•Failure to install retainer cap may cause wheels to come off of stroller.
•After wheel assembly is complete, pull on wheels to check that they are locked into place.
Attaching Cup Holder and Storage Pouch
• Snap one end of cup holder over stroller frame above canopy, rotate down to opposite side and snap in place.
• Snap both straps of storage pouch over stroller handle as shown.
WARNING
•To avoid burns, never put hot liquids in cup holder.
•Avoid possible tipping. DO NOT place more than 3 lbs. (1.4 kg) in cup holder and storage pouch combined.
Adjusting Handle
1 Twist both handle locks inwards until loose.
WARNING
Prevent a possible choking hazard, discard axle protectors and polybag which contained rear wheel parts.
2Grasp center of handle and pull out to desired length.
3Twist both handle locks outwards until they are tight.
DO NOT over tighten handle locks.
4