Operation
REMOVING SEAT
ALL MODELS
Unfasten seat from frame along side tubes.
REMOVING SUNHOOD
ALL MODELS
sunhood support wire
plastic joint
B
A
URBAN
Pull support wire out of sunhood joint,while pushing against frame.
Note:This operation is child proof and therefore requires a degree of force.
Repeat step 1 on other side.
Unfasten the sunhood fabric from the stroller frame and seat near the handle bar.
2Unfasten strap underneath seat at point A. Unfasten frame straps at point B.
REFITTING SUNHOOD
TERRAIN
2Push seat forward, then slide fabric up seat support wire.
3Remove seat support wire from stroller frame at C and D.
seat |
support |
wire |
C D |
Place sunhood in position and push one side of wire into plastic joint. Repeat on other side by pulling wire away from frame at the top. Fasten sunhood fabric to stroller frame and seat, near handle bar.
STORM COVER AND SUN COVER ACCESSORIES
These accessories fasten at the top, around the side tubes.They fit over the sunhood and under the footplate.
REFITTING SEAT
ALL MODELS
Follow removing seat instructions above, in reverse order.
The lower elastic loops fasten onto the lug below the footplate.
X
lug
STORM COVER
strap
lug
SUN COVER
✓ CORRECT
Note: Fasten seat onto frame making sure fabric wraps over and around the top of the side tubes.
WARNING: Do not leave Storm Cover on stroller in warm conditions. Check baby’s comfort frequently when using Storm Cover.
7