figure.
29•To turn the hood into a canopy to shield the child from the sun, open the zipper as shown in the figure and undo the rest of the hood.
COVER
•To transform Uno into the carriage version, first extend the front bar to the
second position and lift the footrest. 30•Slip off the lower part of the hood from
under the footrest sack.
31•Insert the tabs on the lower part of the cover into the slots in the front bar. (The slots on the front bar flip out when the front bar is extended. If the slots slide back into their housing, pull the two little levers under the front bar towards you).
32•Insert the side eyelets into the armrests. 33•Baby carriage without cover.
34•Zip the upper part of the cover to the lower part and position the side eyelets in line with the armrests, as shown in the figure.
35•Button the cover to the armrests, as shown in the figure.
36•Carriage version with cover.
WHEEL REMOVAL
37•To remove the big wheels press the button (A) as indicated in the figure and slip the wheel (B) off.
38•To remove the small wheels push the lever (A) inward and simultaneously slip the wheel (B) off.
CLOSING THE STROLLER
Before closing the stroller, check to make sure that the handlebar is positioned on the same side as backrest. If the hood is attached, pull the side braces upwards. Make sure the four wheels are fixed.
39•To close the stroller, lower the right- hand lever (marked "1") until it clicks into place.
40•Lower the
41•Lower the handlebar to finish closing the stroller, and close the catches as shown in the figure.
When the UNO stroller is closed, it stands up on its own.
TRANSPORT
42•The stroller has a handle on each side, which together allow you to transport it when open (as when going down stairs) or closed.
REMOVABLE LINING
43•To remove the lining from the stroller, remove the flaps on the sack from the armrests and unfasten the buttons.
44•Remove the sack flap from the backrest. 45•Loosen the safety belt from both sides,
and slip the sack off the stroller.
46•To wash the part below the cover, undo attachments from fittings found on the footrest chassis as indicated in the figure.
GANCIOMATIC SYSTEM
The Ganciomatic system, thanks to the Ganciomatic connections, is the quick and practical system which allows fastening the Primo Viaggio car seat, also equipped with the Ganciomatc system and sold separately, to the stroller. Primo Viaggio unfastens from its base (which remain in the car) and fastens to the stroller, allowing you to carry the child without disturbing him/her.
With the Uno stroller you can fasten the car seat in two different positions (“A” and “B”).
STROLLER GANCIOMATIC CONNECTIONS 47•To raise the Ganciomatic connections
on the stroller, lift up the lining in the corners of the seat and turn the two connections upwards.
48•To lower the stroller Ganciomatic connections, pull the lever upwards and simultaneously lower the hook as indicated in the figure.
•Uno can be closed with the Ganciomatic connections raised.
UNO + PRIMO VIAGGIO
49•To fasten the car seat to the stroller in “A” position:
-block the stroller with brakes;
-remove the stroller hood;
-lower the stroller backrest to the second to the lowest position;
-raise the stroller Ganciomatic connections;
-rotate the handle until it is opposite the backrest;
-place the car seat facing the handle;
-fasten the car seat, pushing it down until you hear a click.
50•To fasten the car seat to the stroller in “B” position:
-block the stroller with brakes;
-remove the stroller hood;
-lower the stroller backrest to the second to the lowest position;
-raise the stroller Ganciomatic connections;
-check that the handle is placed on the backrest side;
-extend the front bar to the first click;
-place the car seat facing the backrest;
-fasten the car seat, pushing it down until you hear a click.
•To unfasten the car seat from the stroller see the instruction manual.
LINE OF ACCESSORIES
51•Rain Canopy: Rain canopy zips onto the hood.
52•This rain canopy is designed so that it can