Securing the Child

•Note that there are three height adjustment positions for the shoulder harness straps. For a younger child, the shoulder harness straps should be positioned through the lower opening. For a taller child, the shoulder straps should be positioned through the center or top openings to ensure a good fit.

•To change the positioning of the shoulder straps, find the ends of each strap behind the seat back. Twist the buckle on the end of each strap sideways and push it out toward the front of the seat back through the slot. To re-assemble into a different slot position, twist the buckle sideways and push it through the slot in the seat back from the front toward the back of the stroller. Release the buckle and make sure each strap is not twisted. Pull each strap toward the front of the stroller to be sure it is secure. Be sure that both shoulder straps are inserted through the slots at the SAME height.

•Insure that both shoulder straps are attached to the waist strap buckles. See Figure 17.

•Unlatch the waist/shoulder buckle by squeezing in on both sides of the buckle latch and removing the male ends of each buckle.

•Carefully place the child in the stroller seat with the shoulder straps over their shoulders and chest. Then place the crotch strap between the child’s legs.

•Bring the seat belt around the child’s waist and insert the male ends of the waist/ shoulder buckle into the female buckle. Insure that they snap into place. See Figure 18. Tighten the waist belt to be snug around the child’s waist.

•Both the shoulder straps and the waist/crotch straps may be adjusted using the sliding buckles on these straps. See Figure 19.

Figure 17

Figure 18

Figure 19

!WARNING

Avoid serious injury from falling or sliding out.

Always use the seat belt and harness.

Page 7

Kooper Instruction Manual