you hear the final click: the wheel is securely fastened.
3FITTING THE FRONT WHEELS: To mount the front wheels, lower the lever (fig_a) and click the wheels into place (fig_b).
4FITTING THE FRONT BAR: Attach the front bar as shown in the figure.
5HOOD: To attach the hood, insert the tabs into the notches (fig_a) and button the hood to the rear of the backrest (fig_b).
6The hood can be moved to different positions while your child is sleeping (fig_a). To remove the hood, press the side buttons while lifting the hood off (fig_b).
7CUP HOLDER: The cup holder can be placed on the left or right hand side of the stroller, thanks to the attachment which is already fitted on both sides. To fit the cup holder, click it on (fig_a). Fitted cup holder (fig_b).
8BRAKE: Press down on the brake lever situated on the rear wheel unit to set the brake on the stroller. Lift the lever to release the brake. Always set the brake when the stroller is at a standstill.
9
10In order to put on the safety belt, pass the strap adjustor through the slot in the backrest (fig_a) and detach it after strapping the child in, thus allowing more freedom of movement (fig_b). The strap adjustor must remain below the child’s shoulders so that the straps do not slip (fig_c).
11ADJUSTING THE BACKREST: To recline the backrest, lower the backrest adjuster button while pushing the backrest down (fig_a). To raise the backrest, push the backrest adjuster button upwards (fig_b).
12SWIVELLING WHEELS: Lower the lever (fig_a) to allow the front wheels to swivel. Lift the lever for fixed wheels (fig_b).
13FRONT
14REPLACING THE BASKET: If it is necessary to replace the basket, fasten the front of the new basket to the hooks (fig_a) and close the buttons on the back (fig_b).
15REMOVING THE WHEELS: The wheels on the stroller are removable. To remove the front wheels, set them to swivel, press the levers (fig_a) and at the same time push the wheel until it comes off (fig_b).
16To remove the rear wheels, press the button (fig_a) and at the same time push the wheels down until they come off (fig_b).
17FOLDING UP THE STROLLER: If the hood is attached, close it before folding up the stroller. To close the stroller, move the handle in the same way as you do when opening it: press the button (1) on the handlebar and at the same time push the handle (2).
18Push the backrest and the hood towards the stroller, while lowering the handlebar into its housing (fig_a). Check to make sure that the stroller is fastened securely with the safety clip (fig_b). The
19REMOVABLE LINING: To remove the lining from the stroller, first of all remove the hood, then remove the little cover on the side by pressing on it (fig_a). Push the pin upwards and then outwards (fig_b). Slip the pin out of the hole in the sack. Repeat on the other side.
20To detach the sack from the seat, remove the leg divider from under the seat (fig_a), and