Removing/Attaching the Seat Cushion

Removing

1.Unbuckle the 5-point harness and pull all the straps through the seat cushion.

2.Grasp the seat cushion at the top and unfasten from the velcro.

Attaching

1.Pass the 5-point harness straps through the appropriate locations in the seat cushion.

2.Fasten the velcro.

CAUTION

If seat cushion is ripped or torn, do not use. Do not use the stroller without the seat cushion.

Folding the Stroller

Figure A

1.Raise the backrest to the upright position.

2.Fold the canopy by lifting the canopy levers.

3.Lift up and hold the Folding Levers located on each side near the top of the handle as shown in the Figure (A). Then, tilt the stroller backward until it starts to fold.

4.Grasp the guardrail and handle in opposite hands and pull together.

5.Engage the folding latch on the side of the stroller as shown in the Figure (B).

6.Rotate handle to fold position as shown in the Figure (C).

Folding Levers are located below the handle adjuster buttons on each side of the handle.

Figure B

Folding

Latch

Figure C

-6 -