InStep SB150 manual To convert stroller to a frame carrier

Page 5

To convert stroller to a frame carrier

WARNING: Please request the help of another adult to help you put the frame carrier on.

1.With rear wheels locked, release the frame carrier waist strap cover located between the front legs.

2.Tilt the stroller back slightly, and slide the booties onto the front wheels. This will prevent your clothes being soiled by the wheels.

3.Release the waist buckle and sternum (chest) buckle (Picture M).

4.To close the stroller, step behind the stroller, pull back on the side latches until they clear the locking pegs, handle will automatically fold down when stroller/carrier is lifted off the ground.

5.With the help of another adult to steady the child in the seat, stand in front of the carrier. Place one arm through the shoulder strap and lift carrier onto your shoulder/back. You will find this much easier if the other adult also assists you with holding the other shoulder strap and guiding it over your other shoulder.

6.Once both shoulder straps are on, pull down on the shoulder strap ends to tighten. This will position the child higher onto your shoulders (Picture N).

7.Adjust the height of the sternum straps by sliding them up or down. Clasp the sternum buckle. Pull the ends of the sternum straps to tighten (Picture N).

8.Buckle the waist strap and pull end of the waist strap to tighten (Picture N).

M

 

Shoulder

 

Strap

 

Waist Strap

Sternum

Cover

 

Strap

Sternum

 

Sternum

Height

Adjustment

Buckle

Slides

 

Waist Buckle

 

N

Sternum Strap

Sternum Strap

Waist Buckle

Shoulder

Strap Ends

Waist Strap

5

Image 5
Contents SB150 STROLLER/FRAME Carrier SB150 Operating Instructions Safety RulesStroller Assembly Instructions SB150 Assembly InstructionsParts List Unfold StrollerRear Wheel Asembly Canopy AssemblyTo engage rear brakes Use InstructionsTo close stroller To convert stroller to a frame carrier To clean seat Care and MaintenanceTo clean canopy To clean frame