Operating Instructions Run Around™ & Run Around™ LTD
Front Fender Assembly
Insert the #8 – 1.5" screws into the holes located on the front support above the wheel. Align the holes on the bottom side of the fender with the screws and tighten with a Phillips screwdriver.
Parent Console Attachment (not included with KS107)
The parent console will attach to the handle by snapping it in place on the handle and above the canopy.
Tether/Wrist Strap Attachment
The wrist strap has different sized loops. The large loop will go on your wrist; the small loop will be on handlebar. Slide end with large loop through the small loop, then grasp the end with the large loop and pull strap to tighten on handlebar.
Caution: Whenever child is in stroller always use the wrist strap. Before you remove the wrist strap from your wrist make sure you first engage the rear brakes.
To Engage Rear Brakes
Step on the levers next to the rear wheels until the cogs of the brakes engage the cogs of the wheel. Repeat on other side. To release brake, lift levers using your toe until cogs disengage.
To Operate Front Caliper Brake:
The front brake operates the same as a bicycle hand brake. Squeeze lever located on handlebar to engage front brake. Release lever to disengage.
PROPER USE OF SEAT BELTS & SHOULDER STRAPS
WARNING: Avoid serious injury from falling or sliding out. Always use seatbelt.
Place child in seat. Make sure
Slide waist straps through lower loops of shoulder straps, bring lap belt ends together and clip into place around child’s waist. Adjust waist and shoulder straps for snug fi t.
To recline seat
To fully recline, unhook buckle on back of the seat.To adjust the recline position; adjust the slide on the strap to the desired length.
WARNING: Child may slip into leg openings and strangle. Never use in a reclined carriage position unless
Storage and folding
WARNING: Always remove child from stroller before folding
Pull the back of the seats forward. It will be easier to fold if the seats are not in the recline position. Remove locking pins from side latches on the stroller frame (Double Models have 2 locking pins). Release the two latches from the frame. The stroller may automatically begin to fold, the front wheel will fold under frame and the handle will fold backwards. For a more compact fold remove front and rear wheels
Storage and folding