Operating Instructions Mall Cruiser™ 11-KS288...page 2
Parts List: |
|
Description | Qty. |
Frame assembly with seat, | 1 |
canopy, and wrist strap |
|
Front Wheel | 1 |
Parent Console | 1 |
1 | |
Rear Wheels | 2 |
Front Fender | 1 |
#8 – 11.2" Phillips head screws | 4 |
Tools Required: Phillips screw driver, adjustable wrench.
Stroller Assembly Instructions
Unfold Stroller: Remove from carton, and remove any packaging materials that may be holding the frame in closed position. Grasp frame handle and open. Lock both plastic latches, on sides, onto the lower frame, insert locking pin into hole in latch and frame, lock the pin in place by slipping the wire loop over the end of the lock pin, repeat for the other side. {see Figure 1.A}
Rear Wheel Assembly
Grasp rear wheel in one hand, slide wheel’s axle into hole in rear of frame. Push up on the axle release lever so that the wheel is fully inserted. Pull the wheel firmly, the wheel should not come off if fully inserted/locked. Repeat for other side. To release wheel push up on axle release lever and pull off wheel.
Rear Wheel Assembly - {Figure 1.b}
axle release lever
Front Wheel Assembly
Tip stroller back so that the handlebar is down on the ground and the front fork is up. Attach the front wheel by loosening the wheel’s Quick Release (Q/R) lever on the front wheel far enough to allow the axle to slide into the front fork. With wheel’s Q/R lever in open position, hand tighten the cone nut until almost tight, then flip wheel’s Q/R lever backward to the closed position to lock wheel in place. Note this step may require minor adjustment until the Q/R lever flips back with firm pressure. Pull outward on wheel to ensure it is locked in place.
(photo = open and closed lever)
Caution: The interior jam nuts are factory installed and do not need adjustment.
NOTE: This product has a swivel wheel that can rotate or be locked in place. To lock or unlock the wheel use the switch placed on the top of the fork. The wheel should always be locked in place when used as a jogging stroller. {Figure 1.a}
Front Wheel Assembly - {Figure 1.c}
lever
(open position)
Front Fender Assembly
Insert the #8 – 1.5" screws into the holes located on the front support above the wheel. Align the holes on the bottom side of the fender with the screws and tighten with a Phillips screwdriver.
Parent Console Attachment
The parent console will attach to the handle by snapping it in place on the handle and above the canopy.