Chariot Carriers 51100442 manual Check attachment of all wheels

Page 16
Fig. 28

Check attachment of all wheels.

This jogging stroller is equipped with quick release wheel retention mechanisms. The quick release allows the wheel to be installed and removed without tools. For proper and safe performance, read and follow these instructions carefully:

1. Check all wheels of your jogging stroller before every use.

OPEN

CLOSED

CLOSED

CLOSED

OPEN

OPEN

OPEN

OPEN

OPEN

Fig. 24

Fig. 25

Fig. 26

Fig. 27

Front wheel

2.For the front wheel, move the quick release lever to the OPEN position and set the wheel so it firmly touches the inside of the fork ends.

3.With the lever about halfway between the OPEN position and the CLOSED position (Fig. 24), tighten the quick release adjusting nut on the opposite end of the quick release axle until finger-tight (Fig. 25).

4. Place the quick release lever in the palm of your hand and

move the lever in a motion as shown in Figure 26. Move the lever into the CLOSED position (Fig. 28). At the halfway closed

position of the quick release lever, you should start to feel some resistance to this motion.

5.If the lever is moved to the CLOSED position with little or

no resistance, clamping strength is insufficient. Simply return the lever to the OPEN position, tighten the quick release adjusting nut further and close the lever, testing again for resistance. When

the quick release device is properly tightened, and clamped to the closed position, the clamping force is adequate to cause metal

into metal engagement (embossing) of the fork surfaces.

•Do not tighten the quick release by using the quick release lever like a wing nut (Fig. 27). This will not result in sufficient force to hold the wheel in place.

6.Orient the quick release lever so that it does not interfere with any other stroller part and so that it will not become accidentally snagged by obstacles in the path of the jogging stroller (Fig. 28).

Push button Hub Clevis Axle

Fig. 29

Note: If your dropouts don’t appear parallel, this is normal

when the wheel is not inserted and tightened, especially the Cavalier 2. First ensure that both handlebar height adjustment levers are oriented in the same direction (see page 12) and the locking tension bar is correctly seated. It may be possible to slightly correct minor twisting. Use moderate, gradual movements with hands only (no tools, feet or force) to tweak in the desired direction. The bolted aluminum construction allows for slight corrections.

15

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Cavalier Congratulations Table of Contents Before each use Checklist IMPORTANT! Read Before YOU USEBefore your first use During each useBefore Your First USE ONE Stroller FoldingMake sure you are familiar with your jogging stroller Folding the jogging strollerBefore Every USE Checklist Check that your wheels are straightCheck your tire inflation Check your brakeBefore Each USE Checklist ONE Check attachment of all wheelsGuide for Safe UseRear wheel Test for wheel retentionUSE Safely During Every USE ONE Guide for Safe Strolling Wear a helmetKnow and observe your local pedestrian laws Do not use unsafe jogging stroller practicesKeep your jogging stroller clean Avoid leaving your jogging stroller out in the weatherUse proper storage for your jogging stroller Safely transport your jogging strollerChild Safety and Restraint System ONE Guide for Safe UseINSPECTION, ADJUSTMENT, and Lubrication Periodic Maintenance ScheduleTWO Inspection Adjustment Lubrication Introduction Handlebars Three Fabric and Fasteners InspectionInspection Adjustment Lubrication Brake SystemWheels Three Check attachment of all wheels Rear wheel Additional Features Adjustable SunshadeTracking adjustment Reclining seatParts List Cavalier1 Parts List Cavalier2 Limited Lifetime Warranty
Top Page Image Contents