Rear wheel.
7.Insert the rear hub axle (Fig. 10) into the axle tube (Fig. 11) until the locking clip engages. You should hear a click as this happens, and the clip spring should sit against the axle tube.
Test for wheel retention.
8.Do these two tests to ensure that you have adequately performed these procedures:
•Pick the front of the stroller off of the ground, and give the top of the front tire a sharp downward blow (Fig. 12). The wheel should not come off, be loose, or move from side to side. If uncertain, repeat the tightening process, as shown in Steps
•With the quick release lever properly adjusted and in a closed position, you will not be able to rotate the quick release lever in a circular motion parallel to the wheel (as opposed to the flipping motion used to open and close the quick release lever- see Fig. 13).
9.For the rear wheel, test for a secure attachment by attempting to pull the rear hub axle from the axle tube (Fig. 14). You should not be able to pull the axle from the tube.
Clip spring
Axle tube
Fig. 10 | Fig. 11 |
X
Fig. 12 | Fig. 13 |
X
Fig. 14
7