9.Do not exceed the product’s maximum load capacity of 900 Lbs. Always make sure the load is evenly distributed on the Dolly.
10.Only use on a flat surface capable of supporting the Drywall Dolly and its maximum capacity load of 900 Lbs. It is easy to lose control of the Drywall Dolly if attempting to pull a load on a sloping or uneven surface.
11.Do not allow children to play on, stand upon or climb on the Drywall Dolly. The Drywall Dolly is not for carrying people or animals.
12.Always check hardware and parts after assembling. All connections should be tight and hardware tightened.
13.Always distribute objects in the Drywall Dolly evenly. Uneven weight distribution could cause tipping. Harbor Freight Tools is not responsible for damage to persons or cargo.
14.Be aware of dymanic loading! Suddenly dropping or bouncing a load on the Drywall Dolly may create, for a brief instant, an excess load, which may result in damage to the product and/ or personal injury.
Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Unpacking
When unpacking your Drywall Dolly, check to make sure the following parts are included. If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at
Assembly
Your Drywall Dolly will require complete assembly. It is important that you read the entire manual to become familiar with the product BEFORE you assemble and use the Dolly. Before operating the Drywall Dolly, be sure that you have all parts described in the Parts List and Assembly Diagram page 5 of this manual.
1.Set the Caster Base (B) down on your work bench or work surface. Locate both 8” Swivel Casters (C). The 8” Swivel Casters (C) will be installed on the front (narrow) side of the Caster Base (B).
2.Set the 8” Swivel Casters (C) so the holes in the plate line up with the holes in the Caster Base (B). Insert four Bolts (1) up through the plate and Caster Base (B), slide on Washers (2), and thread on Locknuts
3.Install the 8” Rigid Casters (D) on the rear of the Caster Base (B). Set the 8” Rigid
Casters (D) so the holes in the plate line up with the holes in the Caster Base (B). Insert four Bolts (1) up through the plate and Caster Base (B), slide on Washers (2), and thread on Locknuts
4.Set the ends of the down tubes on Handle (A) into the fittings on the Caster Base
SKU 94883 | For technical questions please call | Page 3 |