Planar PD7150 Connecting the Projector to a Computer, Secure the cable connectors by tightening

Connecting the Projector to a Computer

Connect the projector to the computer
using an HD 15-pin VGA cable.	Optional	HD 15-pin
• Secure the cable connectors by tightening
	accessory	VGA cable
the screws on both sides of the plug.

Notes

•See page 39 “Computer Compatibility Chart” for a list of computer signals compatible with the projector. Using computer signals other than those listed may cause some of the functions not to work.

•When connecting the projector to a computer using an HD 15-pin VGA cable, set the “Input Source” to “PC” in the “Main” menu, or select RGB mode by pressing the Source 3 or 4 button on the remote control.

•A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest authorized service center or dealer.

•Depending on the computer you are using, an image may not be projected unless the signal output setting of the computer is switched to the external output. Refer to the computer operation manual for switching the computer signal output settings.

Notebook Computer		HD 15-pin VGA cable
		(sold separately)
	To VGA output terminal

HD 15-pin VGA cable (commercially available)

				DVI-D
				-HD
		COMP2		RGB
			Y	D-IVD
	1	P /C
COMP		P /C
	Y			RGB
P /C				HD-
			Y
		/C	P
		/C P	OC
	Y	2P M
/CBP
P
1P M	OC
				-240
				AC110

Connections and Setup

RS-232	AC1
	240-10

12