Assembly
Read the entire Important Safety Information section at the beginning of this document including all text under subheadings therein before set up or use of this product.
1.Locate the Main Wing and Fuselage.
Remove the tape covering on the center of the Fuselage. Adhere the Wing to the Fuselage making sure that the center of the Wing lines up with the center of the Fuselage. Use a small pin or apply slight pressure to hold the wing in place until the adhesive is tightly in place.
Wing
Support
Figure 1-Wing to Fuselage
2.Peel off the cover from the two small pieces of adhesive tape on the underside of both wings. Adhere the two Wing Supports to the
Figure 2 -Stabilizer to Fuselage
3.Peel off the covering from the adhesive tape located on the bottom side of the Fuselage Tail. Making certain that the mid point of the Stabilizer is lined up with the midpoint of the Fuselage, attach the Horizontal Stabilizer to the
REV 09k
Figure 3 - Landing Gear
4.While squeezing the legs of the Landing Gear together, insert legs into the slot on the bottom of the Fuselage. After the Landing Gear is inserted, release pressure on the Landing Gear Legs so that they snap into place and are held in their slot on the
Figure 4 - Propeller to Motor
5.Plug the Propeller Spinner set on the Motor. Make certain that the Propeller fits tightly on the Motor
4.
Charging
1.If the temperature is lower than 55° F, warm the battery by holding it or bringing it indoors to a warmer temperature before charging. Do not heat the battery with a flame.
2.If the battery is hot or warm from previous use, allow it to cool to room temperature before charging.
3.Insert two ‘AA‘ batteries into the charger.
CAUTION! Position batteries in proper polarity and do not install batteries of different types, charge levels, or capacities together.
SKU 42619 | For technical questions, please call | Page 3 |