| Assembly |
|
1 | 1 |
|
8 |
| |
| 10 | Plastic |
| Seat Back | |
|
| Connector |
Socket
Connector
Table
Back View
•Locate the connector coming from the table base.
•Insert and “snap” the connector into the socket on the underside of the table top.
•Tuck the excess wire from the connector back down into the opening in the table base.
91
•Fit the plastic connector to the back of the table and in front of the seat back.
Note: Make sure the plastic connector is in front of the seat back.
11
Table Top
| • Align the holes in the plastic connector with the holes in the |
| table. Insert two screws into the plastic connector and tighten. |
• Turn the table top left, towards the seat back, as far as it will go. | Assembly is now complete. |
Hint: You may need to hold the table top in this position for the next two assembly steps (10 and 11).