Assembly
8
Tab
Slot
Base
•Place the base on a flat surface with the open side facing up.
•Set the main assembly onto the base. Fit the tabs on the bottom of the main assembly into the slots in the base.
•Press down on the main assembly to "snap" it into the base.
|
| Small Front |
10 |
| Panel Connector |
Counter Top |
| |
| Stove Top | Connector from |
|
| Counter Top |
Oven Door
•Position the counter top over the main assembly so that the stove top is over the oven door.
•Plug the remaining small connector from the main assembly into the connector from the counter top as shown.
9 | 11 |
Hinge
•Position the refrigerator door with the handles facing you.
•At an angle, fit the refrigerator door lower peg into the lower hole in the hinge on the side panel.
•Then, "snap" the refrigerator door upper peg into the upper hole in the hinge.
•Fit the counter top onto the main assembly.
•Insert 10 screws through the main assembly and into the counter top. Tighten the screws with a Phillips screwdriver. Do not
5