Century PM-1863AB manual Combination Lap/Shoulder Belt with Sliding Latch Plate, Pull

Page 26

VEHICLE SEAT BELTS (continued)

Combination Lap/Shoulder Belt with Sliding Latch Plate

With Harness System:

Pull on latch plate (fig. a). If belt slides freely through latch plate, a locking clip MUST be used. (See “Locking Clip”section.)

Without Harness System:

This vehicle seat belt system is OK to use with booster car seat.

Movement of the seat belt through the latch plate can allow an active toddler to slide down in car seat and re-position lap belt over abdomen and shoulder belt over neck or face which is dangerous.

A Locking Clip may be used on this type of vehicle seat belt to prevent movement of seat belt through latch plate limiting toddler’s movement:

1Install car seat and adjust lap/shoulder belt snugly around child.

2Hold seat belts together at latch plate (fig. b - page 25) then unbuckle.

Pull

(fig. a)

3Slide locking clip on seat belts approximately 1/2 inch (1 cm) away from latch plate (see illustration page 25).

4Re-buckle seat belt.

24

Image 26
Contents Avoid injury or death Read and understand this manual Table of Contents Important Information Registration InformationPage Page Basic Information Outgrowing Car Seat Height and Weight LimitsWith Harness System Without Harness SystemInstallation with harness system Installation without harness system Placing Child in CAR Seat with harness system Placing Child in CAR Seat with harness system Placing Child in CAR Seat without harness system Placing Child in CAR Seat without harness system Buckle Operations and AdjustmentsHarness Tie Tether Strap fig. bLoosen Tighten Adjuster Harness Straps fig. c Changing Harness Strap Slots Fig. c Metal Plate Minimum Inches Fig. eHarness System removal and re-assembly RemovalClip With Shield On some models Vehicle Seat Belts Flip Without Harness System Lap Belts Manually AdjustableVehicle Seat Belts Lap Belts With Retractor With or Without Harness System Passive Restraint Lap Belt with Motorized Shoulder BeltPassive Restraint Lap or Shoulder Belt Mounted on Door Belts Forward of Seat Crease Combination Lap/Shoulder Belt with Locking Latch Plate With Harness System FlipCombination Lap/Shoulder Belt with Sliding Latch Plate PullLocking Clip Installation of Anchor Hardware Additional InformationAdditional Information Tether StorageRemoving Armrest Pads Care & CleaningRemoving Seat Pads Seat Pad and Armrest Pads Aircraft UseSecond Hand Car Seat Harness StrapsCall US First