PLACING CHILD IN CAR SEAT - without harness system
WARNING
To prevent serious injury or death:
•Use ONLY the vehicles Lap/Shoulder Belt system when restraining the child in this booster seat.
•Shoulder belt MUST be properly positioned over shoulder (NOT touching child’s neck and NOT low off shoulder).
•Lap/shoulder belt MUST be properly positioned exactly as shown in illustration.
•Always tighten shoulder belt. NEVER position belt under child’s arms (fig. a).
•Never use a vehicle
•DO NOT allow child to slide down in car seat which could position lap belt across child’s abdomen and shoulder belt over neck or face.
•If child will not keep vehicle shoulder belt properly positioned, DO NOT use this booster car seat. Use a different child restraint system.
•Vehicle belts MUST lay flat against child and MUST not be twisted.
Remove harness system (see “Harness System - removal and
1Place child in car seat with child’s back flat against back of car seat.
2Place shoulder belt across child’s chest.
3Buckle belt and pull shoulder belt to adjust lap belt snugly.
Shoulder belt MUST lay across child’s shoulder in red zone as shown (fig. b). If outside of
red zone, see next steps for Comfort Clip® use.
CAUTION:
Some shoulder belts with (emergency locking) retractors allow a child to pull belt out and change position of belt. Use of Comfort Clip® helps prevent child from pulling belt out.
4Thread shoulder belt through Comfort Clip® exactly as shown and hook end of Comfort Clip® through proper loop of webbing (fig. c).
5Check to be sure shoulder belt is properly positioned over shoulder in red zone and snug against child.
6Position Head Support (on certain models) in center of car seat with ends pointing down and snap into belt slots (fig. d).
14