To Install Locking Clip:
1.Tighten the buckled belt by pushing down hard on the car seat and pulling hard on the shoulder belt.
2.While pushing down on seat, pinch the two straps together behind the buckle tongue.
Unbuckle the belt without allowing it to slip.
3.Connect lap and
shoulder belts as shown .
4.Rebuckle belt. Check that lap belt does not move by pulling hard. If belt loosens or lengthens, repeat procedure.
Remove locking clip when not using car seat. Store under it’s tab on the back of seat.
½” (1.25 cm)
16