To Assemble Highchair
Step 1.
IMPORTANT: BEFORE attaching feet to highchair, frame MUST be folded exactly as in the drawing below.
Lay highchair frame on floor so it looks like the drawing before attaching feet.
Step 5.
Set chair frame into upright position. Slide the seat assem- bly onto the frame. Press the red latches, located on the plastic leg tubes, to allow seat to slide onto frame.
NOTE: Lowest seat position should NOT rest on top of legs. Pull seat up to lowest latching position.
Lowest latching position
NOT resting on legs
Place a foot top and foot bottom at each corner of the chair frame tube. Insert a screw into the foot bottom, through the hole in the chair frame, and into the foot top. Tighten screws securely, but do not overtighten.
To Attach Seat Pad
Your highchair seat pad will either have 4 attachment tabs
or a pocket on the back. Follow the appropriate instructions below:
Step 2.
Unfold the chair frame as shown. Insert one bolt and one
Step 3.
Hex wrench
SEAT PAD WITH FOUR TABS:
Seat back
Seat
bottom
Step 1.
Place seat pad in seat. Large
Snap end caps into ends of right and left plastic leg tubes.
Step 4.
part of pad goes on seat back as shown. Pull the seat belt through the hole in the middle of the seat pad.
Turn the seat upside down as shown. Match up the “L” or “R” on the plastic leg tubes with the letters molded on the seat back. Slide the leg tubes into the “collars” on the seat back.
Slide the crossbrace tube through the slots under the seat. Then insert the ends of the crossbrace tube into the holes in the leg tubes. (This may be more easily done if the crossbrace tube is held at an angle as shown.)
| Right |
| plastic |
Collars | leg |
tube |
Crossbrace
tube
Step 2.
Push the four tabs on the seat cover into the slots at the top and bottom of the seat.
Step 3.
From the rear of the seat, pull |
|
the four tabs over the plastic | Anchor |
anchors near them. |
5 | 6 |