Graco 3635, 3630 manual To Attach Seat Pad, To Secure Your Child

Page 4

5-POINT HARNESS MODELS (For waist belt models, see next section.)

To Attach Seat Pad

Step 1.

Straps must be removed from seat before pad can be attached. Behind the seat back, locate four plastic retainers on shoulder and waist straps. Push them through the slots to the front and set straps aside.

Step 2.

Place seat pad over highchair.

Step 3.

Push each retainer back through proper hole in rear of seat. Two levels of shoulder holes are provided; choose the level that is at or slightly above your child’s shoulders.

Avoid twisting straps.

Step 4.

Pull crotch strap and buckle through center opening in seat pad.

Step 5.

Attach seat pad by sliding pocket over the back of the seat as shown. Then hook sides of pad over the two tabs on each side of the highchair.

Tabs

Step 6.

Push the two tabs on the bottom of the seat pad into the two slots in the bottom of the seat as shown.

From the rear of the footrest, pull the two tabs over the plastic anchors near them.

If it later becomes necessary to launder or replace the harness, follow the directions above to remove harness straps from highchair.

To Secure Your Child

Prevent serious injury or death from falls or sliding out. Always secure your child in the restraint. Do not depend on the tray alone to hold your child.

Step 1.

Place your child’s arms through the loops created by the shoulder/waist straps and insert the harness buckles into the center buckle housing.

Step 2.

Adjust the shoulder and crotch strap lengths as needed to get a snug fit around your child:

! To tighten shoulder straps, hold free end of strap and slide adjuster away from the free end.

! To loosen shoulder straps, hold adjuster and pull strap back through the adjuster.

Step 3.

Finish by giving a quick tug on the free end until shoulder straps are tight.

Check behind and in front of seat to see that belt is tightly

threaded through retainers and straps are tight.

The position of the shoulder straps can be adjusted for the size of your child. Locate the two plastic retainers behind the seat back, push them through to the front and move them to the higher or lower position as desired.

7

8

Image 4
Contents Models 3630 Customer SatisfactionCongratulations on your purchase of a Graco highchair For future useTo Clean Highchair FRAME, use only household soap From Time to Time Check Your Highchair forStep To Assemble HighchairInsert at end Bracket To Attach Seat Pad To Secure Your ChildTo Adjust Recline Do not adjust the highchair with your child in itTo Use Tray For 5-point harness models, see preceding sectionTo Adjust Height Replacement Parts Adjust the highchair withTo Fold Highchair Your child in it