Set highchair upright.
It should look like this.
Step 8.
Place seat pad in seat as shown. Insert tabs of seat pad into the corresponding slots in the seat. From rear of seat, hook all four tabs over plastic anchors.
To Use Seat Belt
Step 1.
Snap buckle together as shown. Adjust belt as needed to get a snug fit around your child.
Step 2.
Press on prongs at top and bottom of buckle to release.
Prevent serious injury or death from falls or sliding out. Always secure your child in the restraint. Do not depend on the tray alone to hold your child.
If it becomes necessary to remove the seat belt, follow these instructions:
Step 1.
First buckle the belt. Then unthread end of seat belt through the buckle as shown.
Step 2.
Pull other end of the seat belt through the belt retainer as shown.
Step 3.
To rethread buckle, thread the free end of the waist belt back through the belt retainer. The “GRACO” logo must be on the front of the buckle.
Step 4.
Thread belt through Smooth side the buckle as shown.
The left end of the buckle must be smooth side up
to thread the belt in the buckle properly. The
other side of the buckle has teeth.
If you have difficulty getting the belt into the buckle, check to make sure that the smooth side of the buckle is up.
CHECK that the belt is threaded correctly by pulling on the seat belt. The belt should not slip through the buckle.
7 |
|
8 | |
|
|