Graco 6600 manual To Attach the Graco Safety Seat, To Use Parent’s Tray, To Use Bottle Holders

Page 4

The following optional features are found only on certain models:

To Attach the Graco® Safety Seat*

Improper use of this stroller with a carrier may result in serious injury or death.

Do not use this stroller with carriers or safety seats other than Graco® Travel System models.

Read the manual provided with your Graco® Travel System Safety Seat before using the Travel System.

If you do not have the owner’s manual for the Graco® Travel System Safety Seat, call Graco at 1-888-224-6549.

Make sure the stroller is fully assembled according to the preceding instructions, with the tray attached (the safety seat CANNOT be used with the arm bar).

Step 1.

If the stroller is folded, unfold it and RECLINE the stroller seat back to its lowest position.

Step 2.

Push down on the tray to be sure it is securely attached to the stroller.

Step 3.

Unbuckle the stroller seat belt, move the buckles all the way to the loose end of the seat belt webbing, and hang buckles outside of the stroller above the fold release latch.

Step 4.

Step 7.

Slide stroller seat belt webbing through vehicle belt hooks on each side of the safety seat. Tighten stroller seat belt buckles against inside of safety seat.

Step 8.

Pull up on safety seat handle to be sure the safety seat is securely attached to the stroller.

To remove safety seat from the stroller, remove stroller seat belts from vehicle belt hooks, squeeze release handle at back of safety seat, and lift safety seat out of the stroller.

To Use Parent’s Tray*

To avoid burns, never put hot liquids in the parent’s tray. To prevent tipping over, do not place more than 3 lbs. (1.4 kg) on the parent’s tray.

Step 1.

Snap parent’s tray to stroller handle as shown.

To Use Bottle Holders*

Two mesh pockets are provided in rear of basket for infant bottle storage.

Bottle

holders

HELPFUL HINTS

IF WHEEL SQUEAKS, use a light oil (e.g., WD-40,3-in-1, or sewing machine oil). It is important to get the oil into the axle and wheel assembly as illustrated.

WHEN USING YOUR STROLLER AT THE BEACH, completely clean your stroller afterward to remove sand and salt from mechanisms and wheel assemblies.

CARE AND MAINTENANCE

TO CLEAN THE SEAT, remove the screws and plastic clasps and hand wash in warm water with a mild detergent. Drip dry only—seat contains plastic inserts. Replace seat on frame with screws and clasps

Replacement Parts

Instructions for ordering stroller parts:

Complete form below. Your stroller model number MUST be included on the form to ensure proper replacement parts. Your model number can be found on a sticker on the rear leg of your stroller. Payment must accompany your order.

Parts List:

Price:**

Seat

$

21.00

 

Seat pad

$

16.00

 

Canopy

$

18.00

 

Large wheel*

$

8.00

(each)

Front swivel assembly*

$

16.00

 

Rear axle

$

7.00

 

Front axle*

$

7.00

 

Basket

$

16.00

 

Brake wire

$

5.00

 

Arm bar*

$

12.00

 

Child’s tray*

$

13.00

 

Rear axle mount

$

5.00

 

Front axle mount*

$

5.00

 

Hub adapter

$

5.00

 

Storage latch

$

5.00

 

Parent’s tray*

$

12.00

 

* On certain models only.

** Prices subject to change without notice.

IF YOU NEED HELP

If you have any questions, please call toll-free: 1-800-345-4109or visit our Internet website, www.gracobaby.com.

Return the form below with payment to:

GRACO CHILDREN’S PRODUCTS INC.

CUSTOMER SERVICE DEPARTMENT

P. O. BOX 100, MAIN STREET

ELVERSON, PA 19520

Model Number SHIP TO:

If your child is already in the safety seat because you have been using it as a carrier, make sure child is secured with the harness.

Always secure your child with the safety seat harness when using the safety seat in the stroller.

Step 5.

Move the safety seat handle into the carrying position.

Step 6.

Position the safety seat so that the mounting notches fit over the edge of the tray. Push down on safety seat until the attachment latch snaps onto the tray.

To Use Storage Pocket*

To prevent a hazardous condition, do not place more than 2 lbs (0.9 kg) in the storage pocket.

A storage pocket is

 

Storage

located behind the

pocket

seat back.

 

 

*On certain models

when dry.

REMOVABLE SEAT PAD (if so equipped) may be machine washed in lukewarm water on delicate cycle and drip-dried. NO BLEACH.

FROM TIME TO TIME CHECK YOUR STROLLER for loose screws, worn parts, torn material or stitching. Replace or repair the parts as needed. Use only Graco® replacement parts.

TO CLEAN STROLLER FRAME, use only household soap or detergent and warm water.NO BLEACH.

EXCESSIVE EXPOSURE TO SUN OR HEAT could

cause fading or warping of parts.

(Must be filled in)

Seat

Seat pad

Canopy

Large wheel

Front swivel assembly

Rear axle

Front axle

Basket

Brake wire

Arm bar

Child’s tray

Rear axle mount

Front axle mount

Hub adapter

Storage latch

Parent’s tray Total:

Shipping

 

& handling:

$5.00

6% sales tax (PA only):

Total amount due:

Name

Address

City, State, Zip

()

Telephone

Check enclosed

(payable to Graco Children’s Products Inc.)

Charge to credit card: Visa

MasterCard

Discover

Account #:

Expiration date:

Signature:

760-1-99

13

14

15

16

Image 4
Contents Models 6600 Customer SatisfactionTo Unpack Stroller To Assemble Rear AxleTo Assemble Rear Wheels To Assemble Front AxleTo Adjust Back To Adjust Canopy To Fold StrollerTo Unfold Stroller To Use BrakesTo Attach the Graco Safety Seat Replacement PartsTo Use Parent’s Tray To Use Bottle Holders