Adjustable Infant Restraint Base

Storing LATCH

1.For ease of storing, extend LATCH to its maximum length.

2.Locate the storage bars on bottom of infant restraint base .

3.Fasten end of LATCH (without adjustment belt) onto storage bar.

4.Repeat Step 3 for LATCH with adjustment belt. After fastening onto storage bar, pull on adjustment belt to make sure LATCH is securely fastened.

5.LATCH storage should look like this when complete .

Storage bars

Base with LATCH

See infant restraint owner’s manual for

complete installation instructions.

Underside of Base

!You must read and understand both the owner’s manual from the infant restraint and these instructions before using the infant restraint and base. Keep this sheet with the instruction booklet in the pocket of your infant restraint for reference.

!This base can only be used with a Graco®

Infant Restraint.

!If you do not have instructions for your infant restraint or if you have any questions about your product, call Graco at 1-888-224-6549 or visit our website at www.gracobaby.com.

Your new infant restraint base is equipped with Graco’s recline adjustment foot, which helps to properly recline the infant restraint/base on the vehicle seat. Use it AFTER you have carefully followed all of the steps in your infant restraint owner’s manual.

ecline the infant restraint/base on the vehicle seat. Use it AFTER you have carefully followed all of teps in your infant restraint owner’s

The adjustable base is used along with the level indicator on the side of your infant restraint. To check the proper angle of the infant restraint, first make sure the vehicle is on level ground and that the infant restraint/base is not tilted sideways on the vehicle seat. Then check the level indicator. You must look straight on at the indicator.

If the indicator shows ONLY blue, the infant restraint is properly leveled.

If any orange is showing in the level indicator, the infant restraint is either too upright or too reclined.

To lower the foot: pull down on the bottom of the foot to the desired setting to adjust the recline .

To raise the foot: set the base on a flat surface, push in on the fingers on the base and push down on the base to adjust the recline .

If there is still orange in the level indicator when the foot is completely extended then place a rolled towel under the foot until ONLY blue shows. Tighten belt through base, then reinstall infant restraint. Level indicator should now show ONLY blue—if you still see orange, re-adjust recline .